Enum daisy::pac::i2c1::cr2::START_A

pub enum START_A {
    NoStart = 0,
    Start = 1,
}

Start generation This bit is set by software, and cleared by hardware after the Start followed by the address sequence is sent, by an arbitration loss, by a timeout error detection, or when PE = 0. It can also be cleared by software by writing 1 to the ADDRCF bit in the I2C_ICR register. If the I2C is already in master mode with AUTOEND = 0, setting this bit generates a Repeated Start condition when RELOAD=0, after the end of the NBYTES transfer. Otherwise setting this bit will generate a START condition once the bus is free. Note: Writing 0 to this bit has no effect. The START bit can be set even if the bus is BUSY or I2C is in slave mode. This bit has no effect when RELOAD is set.

Value on reset: 0

Variants

NoStart = 0

0: No Start generation

Start = 1

1: Restart/Start generation

Trait Implementations

impl Clone for START_A

fn clone(&self) -> START_A

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Debug for START_A

fn fmt(&self, f: &mut Formatter<'_>) -> Result<(), Error>

Formats the value using the given formatter.

impl PartialEq for START_A

fn eq(&self, other: &START_A) -> bool

This method tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

This method tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for START_A

impl StructuralPartialEq for START_A